Warn M8000 26502 | 1813246
Warn M8000
Warn M8000 Winch 26502 | Roundforge
Warn M8000-S Winch 87800 | Roundforge
WARN M8000 Truck Winch Parts – Montana Jacks Outpost
WTJF Blackjack Warn Midframe Resource Thread
Need:
- mounting harware
- winch plate
- synthetic line 3/8" Synthetic Winch Rope - 20,000 lb. Breaking Strength | TRE
- thimble
- hawse fairlead
- earth connection bolt M8 x 1.25 x 12mm Cap Screw
- ground wire 2 gauge, 3/8 connectorsa Spartan Power Custom Heavy Duty Terminated Battery Cables
- Philips Moly Low Temp #1 grease Phillips 66 Moly Low Temp Grease for Planetary Gear Winches – Montana Jacks Outpost
- soleniod - https://www.amazon.com/dp/B082HMDMLG/
- wiring kit? - https://www.roguefab.com/product/brute-winch-wiring-kit-front-rear/
- wiring loom Todo:
- clean up
- repair remote port
- paint?
- warn “W” decal
Mounting Hardware 30-35 ft. lbs.
A 4 3/8-16 square nut
- Square nuts, Stainless steel 316, 3/8"-16 - Bolt Depot
- Square nuts, Zinc plated steel, 3/8"-16 - Bolt Depot
- Square nuts, Stainless steel 18-8, 3/8"-16 - Bolt Depot
- Square nuts, Hot dipped galvanized steel, 3/8"-16 - Bolt Depot
B 4 3/8” (9.5mm) washer - SAE flat washers, Zinc plated grade 5 steel, 3/8" - Bolt Depot
C 4 3/8 - 16 x 1 1/4” bolt - Hex bolts, Zinc plated grade 5 steel, 3/8"-16 x 1-1/4" - Bolt Depot
control pack mounting nuts
C 2 M6 x 10
rebuild
reassembly: I would also suggest when you assemble the winch you do it vertically starting with the gearbox end and work up from there. This allows you to make sure that everything is stacking together properly as everything should just “fall” into place as you go. This also allows you to make sure the brake shaft is also the correct length as the motor will not be able to seat to the drum support if it is too long.
HOW TO REPAIR A WINCH - PART 1 (OF 3) - YouTube
HOW TO REPAIR A WINCH - PART 2 (OF 3) - YouTube
HOW TO REPAIR A WINCH - PART 3 (OF 3) - YouTube
pinout
1-brown 2-white 3-black 4-green 5- 6-red
contactor decal
2-5/8 1-3/8
Warn Short Winch Motor - 77893
This 12 volt 4.8 motor can be used to replace your M8 winch motor or can be swapped in to the old-style M8000 winches. The previous part number (25982) is obsolete. The old M8000 motor part number (25982) has been superseded by 77893, which is the correct short winch motor for the M8, the M8-s, and the M8000.